REP Support for Bathpump.com - Q & A

Walter BP Rep

Registered
Well Done !
Joined
May 13, 2015
Messages
2,915
Reaction score
51
Points
68
Location
NJ
I received my first pump, Hydromax7, late last week and have been struggling to avoid making cylinder contact and getting loose skin sucked up. Today, I discovered if I use a loose fitting rubber ring around my testicles and apply the comfort ring over my shaft, to position everything, before applying the cylinder, then it's way more comfortable. Are there any known possible issues with doing either of these things?
If you are not experiencing nay discomfort or injuries from wearing the ring then this is a good way to keep things stable. You also need to be sure to let the pump sit high on the base of your pubic bone to prevent unwanted skin or parts from getting sucked into the pump.
 

8ToGo

Registered
Well Done !
Joined
Dec 1, 2008
Messages
102
Reaction score
15
Points
38
I have the hydromax 30 and am having a problem with it. When I pump up after a few minutes it is getting large air bubbles inside and then it does not have the solid pressure. I have taken the valve out and cleaned it and cleaned the entire thing inside and out. I am also clean shaved so that is not the problem. I cannot find any leakes or holes anywhere. It is about 2 & 1/2 years old, But never had a problem until recently. Any help would be greatly appreciated. Thank You.
Did you gain with it after 2 years and 1/2?
 
  • Like
Reactions: Wauwer

8ToGo

Registered
Well Done !
Joined
Dec 1, 2008
Messages
102
Reaction score
15
Points
38
I get larger bubbles that seem to be coming from the bottom seal against skin around the black bellows part. The seal looks fine, no holes and it is clean. I do not use the comfort pad, I could never get it to seal at all. I just use the black bellows against my skin and never had a problem until recently. Is there a way to recondition the black rubber bellows? Thanks.
i find that it works better in the bath, the suction is stronger and better. Unfortunately, taking a bath is time consuming, shower is best but It takes alot of work to get suction right in the shower.
 
  • Like
Reactions: Walter BP Rep

Walter BP Rep

Registered
Well Done !
Joined
May 13, 2015
Messages
2,915
Reaction score
51
Points
68
Location
NJ
i find that it works better in the bath, the suction is stronger and better. Unfortunately, taking a bath is time consuming, shower is best but It takes alot of work to get suction right in the shower.
You can use the device even without water although it does not feel as good.
 

Gainmax

Registered Users (MTT)
Pretty Good !
Growing ! (ltt)
Well Done !
Joined
Mar 27, 2021
Messages
46
Reaction score
22
Points
28
i find that it works better in the bath, the suction is stronger and better. Unfortunately, taking a bath is time consuming, shower is best but It takes alot of work to get suction right in the shower.
I suggest cutting all hair to 5mm . You can also improve suction by using thick lotion on the rubber ring. Just put a great amount of it and then attach. I have used anal lotion here which is very thick and can easily be bought from any webstore.

Personally, I never use bathmate at the shower. I add water around half-way from top, attach, walk on sofa and sit down. I can pump the excess water out from bathmate to a nearby glass while watching TV.

Unfortunately I don't know how it works with the basic version of Bathmate. I suppose it has the same kind of valve at the tip?
 

Sam R

Registered
Well Done !
Joined
Feb 24, 2021
Messages
312
Reaction score
77
Points
48
Location
Canada
Question regarding HydroMax…have read in various places that you can use the HydroMax “dry”. Assuming this is correct, what adjustments need to be taken care of when performing?

Asking as a long shower or bath is not always achievable and “dry” would be much more convenient and manageable.
 

Walter BP Rep

Registered
Well Done !
Joined
May 13, 2015
Messages
2,915
Reaction score
51
Points
68
Location
NJ
Question regarding HydroMax…have read in various places that you can use the HydroMax “dry”. Assuming this is correct, what adjustments need to be taken care of when performing?

Asking as a long shower or bath is not always achievable and “dry” would be much more convenient and manageable.
This question has a reply here:

 

wheeler775

Registered
Well Done !
Joined
Nov 24, 2020
Messages
61
Reaction score
19
Points
28
Hey Walter (or anyone who may know), the link for the routine in your signature section is dead. Is there a working link for the routine?

Thanks
 

Big Al

Administrator, Editor, Male Enhancement Coach
Staff member
Excellent !
Extraordinaire !
Joined
Apr 19, 2008
Messages
34,368
Reaction score
2,069
Points
133
Website
www.maleenhancementcoach.com
  • Like
Reactions: Walter BP Rep

GainsForABetterLife

Registered
Well Done !
Joined
Nov 27, 2022
Messages
89
Reaction score
35
Points
38
Bathmate recommends distributing the pumps 3 X 5 mins.
How do we proceed after we're somewhat accustomed to the stress?
Little bit confused.
 

Big Al

Administrator, Editor, Male Enhancement Coach
Staff member
Excellent !
Extraordinaire !
Joined
Apr 19, 2008
Messages
34,368
Reaction score
2,069
Points
133
Website
www.maleenhancementcoach.com
  • Like
Reactions: GainsForABetterLife

GainsForABetterLife

Registered
Well Done !
Joined
Nov 27, 2022
Messages
89
Reaction score
35
Points
38
Thanks for the useful info. Amazing community as always.
It seems intense tho. Since I am already using a Size Genetics ADS and jelqing, should up my time slower? Because adding a minute per day seems a bit drastic. Should I just a minute per week? Planning to add weights next month and afterwards do some squeezes. Considering all of the stress my penis will experience, I believe a minute per week is still OK? Thanks again.
 
  • Like
Reactions: Big Al and Alex1988

Alex1988

Senior Member, Member of the Month Aug 2021, PEGy
Well Done !
Joined
Oct 9, 2020
Messages
869
Reaction score
353
Points
83
Location
Banana Tree
Pump for 15 minutes with hot water. Then you're perfectly warmed up to use the Size Genetics extender. If you encounter too much edema lower the Bathmate session to 10 mins.
 
Last edited:
  • Like
Reactions: GainsForABetterLife

closed49752

Closed
Joined
Dec 10, 2018
Messages
72
Reaction score
10
Points
28
Using the Hydromax. I am seeing air bubbles come up from the tip of the device. That seems to be a way to loose vacuum. Is this normal? I lock the pip to fill, then release to the center position to use the device. Once I pump, it works for about 20 seconds, then air starts coming in thru the tip.
If this is an issue, is there a workaround??
 
Last edited:

closed49752

Closed
Joined
Dec 10, 2018
Messages
72
Reaction score
10
Points
28
Well I might have answered my own question. Lowering the device allows air into the valve, keeping it upright (as it says in the instructions) works fine. ALSO I get MUCH better results using in the bathtub. In the shower it is much more difficult to keep a tight seal. If I was completely shaved down there, it would work better for sure.

Thing works darn good in the tub! I will be working this into my new routine starting next month. For now practice with the device.
 

GainsForABetterLife

Registered
Well Done !
Joined
Nov 27, 2022
Messages
89
Reaction score
35
Points
38
I believe prior to filling, you should remove the rubber seal as stated in the tutorial. Then you won't see any bubbles. Works for me at least.
 
  • Like
Reactions: closed49752

Wauwer

Registered
Well Done !
Joined
Jan 2, 2023
Messages
95
Reaction score
48
Points
38
So.. I was at this EU site where they sell Bathmate and saw this disclaimer at the bottom:
"It's not possible to create a permanent enlargement of the penis with a penispump..."

They are selling other enlargement devices where similar disclaimers aren't present.

I was looking at the bathmate for permanent girth-gains, but is it just temporary edema/fluid build-up and not the actual penis that is getting enlarged or what is the deal here?

Ps. Does anyone know the max penis length possible in the hydroxtreme7 before you have to switch up?
 
Last edited: