REP Support for Bathpump.com - Q & A

[Rok]

I have the hydromax 30 and am having a problem with it. When I pump up after a few minutes it is getting large air bubbles inside and then it does not have the solid pressure. I have taken the valve out and cleaned it and cleaned the entire thing inside and out. I am also clean shaved so that is not the problem. I cannot find any leakes or holes anywhere. It is about 2 & 1/2 years old, But never had a problem until recently. Any help would be greatly appreciated. Thank You.

 

[Big Al]

I have the hydromax 30 and am having a problem with it. When I pump up after a few minutes it is getting large air bubbles inside and then it does not have the solid pressure. I have taken the valve out and cleaned it and cleaned the entire thing inside and out. I am also clean shaved so that is not the problem. I cannot find any leakes or holes anywhere. It is about 2 & 1/2 years old, But never had a problem until recently. Any help would be greatly appreciated. Thank You.

Where are the bubbles coming from?

 

[JayThomas]

Question regarding size inside the bathmate... What is an approximate size difference for most people (Length wise) when inside vs outside the pump. For example, I can pump to the 6.25-6.5 inch inside the pump, however my NBPEL is about an inch less.

 

[Negev in Heaven]

I'm having a similar problem and have had mine for about as long as well. The bubbles are coming from the water suction valve at the top of the device. I have the x40 model if that helps. But it looks like where that valve assemble slides into vacuum chamber there are what I assume are O-rings and I have a steady stream of air bubble coming from there. I can send a video if that would help.

 

[Rok]

I get larger bubbles that seem to be coming from the bottom seal against skin around the black bellows part. The seal looks fine, no holes and it is clean. I do not use the comfort pad, I could never get it to seal at all. I just use the black bellows against my skin and never had a problem until recently. Is there a way to recondition the black rubber bellows? Thanks.

 

[Walter BP Rep]

Question regarding size inside the bathmate... What is an approximate size difference for most people (Length wise) when inside vs outside the pump. For example, I can pump to the 6.25-6.5 inch inside the pump, however my NBPEL is about an inch less.

Go with the listed size for your pump choices. Check out this size chart for more https://cdn.shopify.com/s/files/1/0151/0593/products/size_guide_1024x1024.jpg

 

[Walter BP Rep]

I'm having a similar problem and have had mine for about as long as well. The bubbles are coming from the water suction valve at the top of the device. I have the x40 model if that helps. But it looks like where that valve assemble slides into vacuum chamber there are what I assume are O-rings and I have a steady stream of air bubble coming from there. I can send a video if that would help.

If you have to replace or clean your valve here's instructions https://www.pegym.com/forums/penis-...p-support-bathpump-com-q-139.html#post1323542

 

[Walter BP Rep]

I get larger bubbles that seem to be coming from the bottom seal against skin around the black bellows part. The seal looks fine, no holes and it is clean. I do not use the comfort pad, I could never get it to seal at all. I just use the black bellows against my skin and never had a problem until recently. Is there a way to recondition the black rubber bellows? Thanks.

If the bubbles are coming from the bellows then there are tears there. If they're coming from the base then the seal is faulty. Some more lube and shaving pubes should help you to get a better seal if this is the problem.

 

[Rok]

Thanks Walter, Is there any recommended type of lubes to put on the black rubber seal that will make it hold tighter?

 

[Walter BP Rep]

Thanks Walter, Is there any recommended type of lubes to put on the black rubber seal that will make it hold tighter?

Silicone based lubes will work well for getting a good seal. Some even use coconut oil.

 

[BallsMahoney]

Hey Walter. Currently using an x30, but am now measuring 7.5x5.4 to 5.5. Is it time to step up to an x40 or should I wait a bit?

 

[Walter BP Rep]

Hey Walter. Currently using an x30, but am now measuring 7.5x5.4 to 5.5. Is it time to step up to an x40 or should I wait a bit?

If you're close to filling up the tube you already have the it would be time for you to get a larger pump.

 

[BallsMahoney]

If you're close to filling up the tube you already have the it would be time for you to get a larger pump.

Definitely close if not already there. After about 10m in the tube my glans begin to touch the wall where the measuring tape is (perfect upward curve lol), and the sides are very close.

Sounds like x40 is my next move. Do you think the extreme model with hand pump is worth it? Sure looks interesting.

 

[Walter BP Rep]

Definitely close if not already there. After about 10m in the tube my glans begin to touch the wall where the measuring tape is (perfect upward curve lol), and the sides are very close.

Sounds like x40 is my next move. Do you think the extreme model with hand pump is worth it? Sure looks interesting.

If you like the convenience of hand pumping which also leaves one hand free then you're going to like the XTreme model.

 

[mookiland]

i have Hyromax Extreme, using it already like 3-4 months

I have noticed there is HUGE different between doing it on the Tub or the Shower, at the tub you almost sure will have 100% water in the tube which means higher pressure but also harder to get higher on the ruler which can be little bit frustrating, however in the shower almost no way not loose some water while insert your penis in, and seems pressure is lower due loss of water and it easier to go higher in the ruler which is more satisfying , but you will have less pump power which i guess its not good

What your thoughts ?

 

[Walter BP Rep]

i have Hyromax Extreme, using it already like 3-4 months

I have noticed there is HUGE different between doing it on the Tub or the Shower, at the tub you almost sure will have 100% water in the tube which means higher pressure but also harder to get higher on the ruler which can be little bit frustrating, however in the shower almost no way not loose some water while insert your penis in, and seems pressure is lower due loss of water and it easier to go higher in the ruler which is more satisfying , but you will have less pump power which i guess its not good

What your thoughts ?

Pumping in the tub is more stable and comfortable. You're also seated which will make a difference from standing, where you're moving around too.

 

[tiritera]

That's a good idea and one that I'll run by the higher ups.

Hallo Walter, any feedback from the engineers?

 

[Walter BP Rep]

Hallo Walter, any feedback from the engineers?

There has been no reply about this yet.

 

[Couchdog]

What would the max HG of the bathpump be? Like fully pumped where there isn't any water?

 

[Walter BP Rep]

Maximum pressure for the bathmates are about 15 mm Mercury.