Getinbig's progress log
- Thread starter getinbig
- Start date
Ahh...that's too bad that the BM didn't show...Oh well, you have plenty o' other PE options in the meantime.
Hey Greg, you're right. I enjoyed two great clamping sessions this morning! Still hoping my BM shows up soon. I'll keep you posted.
I have tried both routines (though I've only ever worked up to 10 minutes without removing the device...I'm trying to avoid overtraining/injury). What I have been doing the past few weeks: following my time in Phallosan I warm up, do some manual stretching (JP90 style), then go into BM for a 5 minute pump at moderate pressure. I remove it, do some massaging, firegoat rolls and jelq for 5 minutes. I reenter the pump with warmer water & increase pressure (been going to around 6" on the gauge--I'm 5.5" BPEL without pump). I have been timing the second pump for 5-7 minutes and trying to increase the time. Afterwards I jelq some more to get the circulation moving around and exercise the tissue further.
Previously I did 3 X 5 minute intervals. Try both!
Can't wait to try at least one of your routines! Just need to get my BM delivered. So much for paying for expedited delivery...
Hey man!
Nice log postsYou seem to be doing well. Excited for you to start the BM out! I personally tried the BM x40 and I like it every once in a while. But I mainly use my air pump. Good luck to you dude! Can't wait for you to try it out.
Hey Swimbarracuda! Thanks for stopping by and checking out my log. I seem to be doing well. Loving my PF work and aiming for 10-11 hours wear each day.
I opted for the X30 BM and hope it comes today. I'd love to try it out and see how that can work into my PF and clamping routine.
Had two great clamping sessions this morning, again with double and triple clamping. I will post a pic showing my triple clamping. You can check how I'm doing that in my clamping album. Comments are welcome.
I'll keep you posted about my BM. Hopefully it's about to arrive.
I'm hoping for both length and girth gains.
I had two great clamping sessions this morning, again with double and triple clamping. I will post a few pics showing my triple clamping. You can check how I'm doing that in my clamping album. Comments are welcome.
I'll keep you posted about my BM. Hopefully it's about to arrive.
Triple Clamping again!
Double and Triple Clamping...
Two clamps this morning.
The first was a 20 minute clamp, with a second and third clamp applied during the continuous clamp. Edging and squeezes when only one or two clamps were being used.
The second clamp was for 16 minutes and again I did continuous edging, my Sliding ULIs as well as some double and triple clamping.
This all began because I want to have a back up clamp in case I pop my clamp. When that happens, I need a new clamp. Having a back up handy, and loving clamping, I was tempted to use that second clamp.
What I did this morning, for example, was to clamp for five minutes and then applied my second clamp just in front of the first clamp. This is never clamped as tight, but as tight as I feel is safe. I left this on for about five minutes and then added my third clamp mid shaft for a minute or so. Then I removed the third clamp and placed it just below my glans. It really becomes quite intense. It's important to be tuned into your PIs and be quick to remove a clamp if there is anything negative going on.
I posted some pics of this in my clamping album.
Double and Triple Clamping...
Two clamps this morning.
The first was a 20 minute clamp, with a second and third clamp applied during the continuous clamp. Edging and squeezes when only one or two clamps were being used.
The second clamp was for 16 minutes and again I did continuous edging, my Sliding ULIs as well as some double and triple clamping.
This all began because I want to have a back up clamp in case I pop my clamp. When that happens, I need a new clamp. Having a back up handy, and loving clamping, I was tempted to use that second clamp.
What I did this morning, for example, was to clamp for five minutes and then applied my second clamp just in front of the first clamp. This is never clamped as tight, but as tight as I feel is safe. I left this on for about five minutes and then added my third clamp mid shaft for a minute or so. Then I removed the third clamp and placed it just below my glans. It really becomes quite intense. It's important to be tuned into your PIs and be quick to remove a clamp if there is anything negative going on.
I posted some pics of this in my clamping album.
I think the BM rep's routine is a solid, good approach. The instructions in my X30 differed from the rep's in that it advises to remove the device every 5 minutes to massage/jelq. I am not sure whether the releasing and re-pumping is better or worse for BM results (there seems to be arguments for both). I was a little surprised that the BM rep would advise a different routine than the manufacturers manual.
My BM did not explain how to measure mmHg. I am a little confused about this as well. It seems logical that you go in erect, notice where you are at on the measure, then pump another .5 inch. The problem I have is I am rarely fully erect upon entry and pumping causes and enhances an erection.....so I've actually seen an inch to 1.5 inch difference (and I usually only go to between 5.5-6 inches on the scale when fully compressed). Sorry I couldn't be more help on this...its not critical to the function, but it would be nice to calculate the pressure.
I can help you on BM use tips: trim pubes quite low (or shave), warm up (balls should be loose, so as to not get sucked into or against the BM cylinder. I use it in the shower (not when I am taking a shower), fill the cylinder in the sink with warm water, step in shower, pull down on scotum as I slide the BM into place against (a little water is lost/displaced from the cylinder), check placement and gently pull down on testicles to make sure they are out of way, then compress the gaitor as you focus on keeping the "comfort pad" pressed firmly against pelvis. Then allow the gaitor to recoil out as you feel the pump engage and your cock becoming more engorged. Sometimes you will get air in the cylinder on the 1st pump and you either have to pump the air out and get it to seal....or restart. You will know if its right because you will feel and see the pump at work. It takes a little practice, but feels great! Enjoy!
Hey Greg, thanks for this info. My BM came and I'm struggling with positioning, losing water, having too much air in the cylinder and forgetting to keep my testicles free before I pump.
A question... the angle in the comfort pad, should that be down or up? It seems to me it should be up so the BM is straight or angled up.
Also, once I pump, I'm losing suction...maybe I haven't pumped enough. How often do you pump at first?
I'm going in flaccid and as a grower, I'm just seeing my glans in the cylinder...well, maybe a bit of the shaft as well.
Didn't want to overuse it, but I probably tried to get it positioned and pumped a half dozen times, leaving it on for maybe a minute or two.
I'd love some guidance if you have anything you think might help. I'm sending this post to you as a PM as well.
Thanks for your help!
Yeah let me know how it goes. Would be interested in the triple clamp photo. I saw the double. Want to know where you place all three? I'm gonna go to the store today and pick up 2 new clamps. I'll start with two and try three out another time. One clamp is already intense, I can't imagine what three would feel like. Hope your BM comes today.
EDIT: Ah just read the post above. I'm happy you got it! Make sure you keep the pad almost straight out really. Not up or down imo. Also, I had issues before where air leaked between the comfort pad and actual end of the pump. make sure its on tight.
Last edited:
Yep! I was really pumped when it arrived. Now I just have to figure out how to pump!
Do you mean I should keep the pump horizontal instead of angled up?
I should be able to get some good pics posted on Monday. I'll try to PM you when I do.
Yeah I think leaving it horizontal is best imo. Maybe not completely horizontal. Somewhere in between. I had issues with balls being sucked in at first. Great! Yeah just let me know man.
Wow! I am amazed at how many hours you can wear that for. What tension level do you use?
Upper green to low yellow. I am really pleased and thankful I'm able to log so many hours without issues.
Just logged another 14 hours for today.
Thanks for your encouraging words!
Last edited:
Separated from my Bathmate. I was frustrated with my first attempt. Had a difficult time figuring how to use it...which may be difficult to understand. I have to figure how to maintain suction...and how to pump. I'm a grower and because of that, I should probably got into the cylinder with an erection or at least a semi. I found I couldn't really visualize much of my cock once I had pumped. I'm sure I'm doing this incorrectly. Probably will try again next week and hopefully I'll figure it out. Any suggestions?
Had some small spots on my glans after jelqing this morning. Haven't seen that in a long time.
I've decided to hold off on PF and PE for a few days to let them clear up...
Rest...time to grow...
I've decided to hold off on PF and PE for a few days to let them clear up...
Rest...time to grow...
Spots quickly faded so decided to do a manual 10 minute clamp this afternoon with some squeezes and KITJs as well. Finished thick and plump. Felt good!
Last edited:
