REP Support for Phallosan Forte - Q & A
- Thread starter Phallosan
- Start date
I will definitely be watching your progress DreamOn. I hope with consistency, we will all reach our goals here at PEGym.
When I get my Phallosan Forte and after my glans become used to the device I might try hanging with it at 5 lbs and try to increase the time by 5 minutes until I get to an hour and ultimately up to 4 hours. I firmly believe that 12 lbs is the most you will ever need in hanging if you can hang for a 4-6 hour session and if the Phallosan can handle 12 lbs then it might just be the greatest device for PE.
LG hanger might seem like a very good hanger and all the only thing I don't like about it is that you can't change it to a ADS system because of its size. I am looking for a device that can either do ADS or hanging and Phallosan might just be the one!
Okay, for me it was a a bit of a struggle trying to roll up the condom to the edge of the suction bell. I was really careful not to tear the condom sleeve (maybe too careful at first) I chose the medium suction bell, and it might be a little bit too big for me right now, because It was losing suction after 30 minutes. I used the suction ball to give it more vacuum and it was good for the rest of the 1 hour session.
The phallosan is super comfortable to wear. I had a hard time ending the 1 hour session, because it is THAT comfortable. You can't compare this extender to other extenders.
I've been using the J.. extender (
remember don't roll condom all the way down leave some of the sleeve exposed so you can stretch the rolled part over the lip. in the directions it say allow .40 unrolled but check my step by step. couple of post back.
Hi guyz,
I don't quite feel that i am stretching my shaft when I pull the stretch to the geen zone. Could it be bcoz I am used to X4 extender pulling at higher stretches that's why feel this way? Or would I be needed to increase my stretch strength if I don't feel stretched in PF?
I don't quite feel that i am stretching my shaft when I pull the stretch to the geen zone. Could it be bcoz I am used to X4 extender pulling at higher stretches that's why feel this way? Or would I be needed to increase my stretch strength if I don't feel stretched in PF?
it could be that you have too much tension on the foam rubber ring, please try this:
When you wear Phallosan forte for example to the right side, go with your hand beneath the tension clip (number 6 in your instructions), now you press the belt away from your body (about 5 cm) and go along around your body until you reach the white rubber foam ring. The main goal is to take away the complete pressure and transfer it to the condom (number 3). You will see that there is no more pull on the white foam rubber ring and the main tension will be where it is supposed to be, on the condom and hard plastic bell.
Please tell me if it helped?
Thanks
Julian
When you wear Phallosan forte for example to the right side, go with your hand beneath the tension clip (number 6 in your instructions), now you press the belt away from your body (about 5 cm) and go along around your body until you reach the white rubber foam ring. The main goal is to take away the complete pressure and transfer it to the condom (number 3). You will see that there is no more pull on the white foam rubber ring and the main tension will be where it is supposed to be, on the condom and hard plastic bell.
Please tell me if it helped?
Thanks
Julian
Hi please send an email to [email protected] and your order number or name. Just include the sizes you want so we send you the 6 free ones asap
Hi BBBB,
great to hear, and nice that everyone helps each other
There is probably a missunderstanding, we do not have a measuring tape but a measuring tool (its the one you measured your girth with, where it says: pull the penis away from the body.....) .
Have you already sent an email to us in order to get the 3 sleeve condoms for free?
BR
Julian
great to hear, and nice that everyone helps each other
There is probably a missunderstanding, we do not have a measuring tape but a measuring tool (its the one you measured your girth with, where it says: pull the penis away from the body.....) .
Have you already sent an email to us in order to get the 3 sleeve condoms for free?
BR
Julian
Yes at the beginning it is, this is why we have the step to step plan so you know after one hour if the force of the belt is a little too much.
I would suggest you to decrease the pull a little. But dont worry nothing can happen. If you feel that there is more blood then normal, it is only positive, fitness for the penis
at the beginning it is, this is why we have the step to step plan so you know after one hour if the force of the belt is a little too much.I would suggest you to decrease the pull a little. But dont worry nothing can happen. If you feel that there is more blood then normal, it is only positive, fitness for the penis
IMPORTANT
Hi Gstylzee and everyone else
it can happen that the pump starts losing its pressure or suddenly does not create an vacuum anymore. This happens very rarely but it can happen.
This is why i tried my best to describe you the problem with the picture below.
Number 1 shows you where the upper valve is or should be, but sometimes it move downwards like the arrow shows. So you can remove the number 2 and push it up again or send us the pump so we can replace it for free of course! You do not necessarily have to remove number 2 as you can easily move number 1 up again. Sometimes customers or patients really want to know what’s inside this pump and are afterwards not able to fix it again, if that happens to someone, just tell us the truth as we will anyway replace it for you for free. But for us it is very important if it was a problem creates by the user or us.
I really hope this picture makes sense
Hi Gstylzee and everyone else
it can happen that the pump starts losing its pressure or suddenly does not create an vacuum anymore. This happens very rarely but it can happen.
This is why i tried my best to describe you the problem with the picture below.
Number 1 shows you where the upper valve is or should be, but sometimes it move downwards like the arrow shows. So you can remove the number 2 and push it up again or send us the pump so we can replace it for free of course!
You do not necessarily have to remove number 2 as you can easily move number 1 up again. Sometimes customers or patients really want to know what’s inside this pump and are afterwards not able to fix it again, if that happens to someone, just tell us the truth as we will anyway replace it for you for free. But for us it is very important if it was a problem creates by the user or us. I really hope this picture makes sense
Thanks Julian. No, I haven't ordered my condom sleeves yet. I need to take sometime to know which size do I exactly need before I decide.
What could be the reason of loosing suction? The pump is right in its locking position, no powder inside the sleeve condom to cause lost of suction and intially I pumped till the tip of my gland(covered with protector) touched the end of the bell. But still I noticed lost of suction.
What could be the reason of loosing suction? The pump is right in its locking position, no powder inside the sleeve condom to cause lost of suction and intially I pumped till the tip of my gland(covered with protector) touched the end of the bell. But still I noticed lost of suction.
imac
Retired Moderator, Member of the Month Nov 12, PE
When you pumped it up did you make sure there wasn't any little pockets of air in the condom sleeve? The first time I lost suction I noticed there was a little bit of air where my penis entered the bell, so I re- applied, this time making sure there wasn't any air pockets between the bell and the sleeve once I'd pumped it up, and that the sleeve was actually sucked into the bell a bit creating a good seal.
Hi Julian i bought my phallosan through a reseller,do i qualify for free condoms as well?Mine ripped up after 10 days use
Another question:
My gland can only get in the bell(medium siz3)after putting on the protector cap of which squeezes my glan to a less than half its size and that's where I can insert inside the bell. Otherwise, my gland wouldn't go inside the medium bell even flaccid state let alone the reqired erect state while mounting the equipment. Now imagine after two weeks where I am supposed to set the extender without the protector cap. How can I insert the gland in the protector cap by then?
Also I have noticed lost of suction. Intially the tip of the gland would be right to the end of the bell. After 10 min I would find it almost 0.4'' further from the end of the bell. Where wud I be wrong? I wear the protector cap while erect and put on the sleeve condom while flaccid. Am supposed to be erect while putting on the sleeve condom as well?
My gland can only get in the bell(medium siz3)after putting on the protector cap of which squeezes my glan to a less than half its size and that's where I can insert inside the bell. Otherwise, my gland wouldn't go inside the medium bell even flaccid state let alone the reqired erect state while mounting the equipment. Now imagine after two weeks where I am supposed to set the extender without the protector cap. How can I insert the gland in the protector cap by then?
Also I have noticed lost of suction. Intially the tip of the gland would be right to the end of the bell. After 10 min I would find it almost 0.4'' further from the end of the bell. Where wud I be wrong? I wear the protector cap while erect and put on the sleeve condom while flaccid. Am supposed to be erect while putting on the sleeve condom as well?
I just sent you a mail for 4 small and 2 medium condoms, Julian.
I have to admit, the Forte is causing a lot of frustration at the moment. It keeps losing suction, no matter how perfect I apply it. I also have a hard time getting it right even though I am up to 20 times already putting it on and off.
The medium bell was too small for me, yet the medium condom too big. So that means small condom fits me, problem is, I have to use the medium bell for that, which is a bit too small.
I don't have the right to complain much, because I got mine for free, but I really just wish it could stick on for at least 3-4 hours without losing it suction every 10-20th minute.
I have tried the different techniques on rolling the condom over the penis, but almost every time I do it, the condom gets inverted somehow, and doesn't stick perfectly.
I have to admit, the Forte is causing a lot of frustration at the moment. It keeps losing suction, no matter how perfect I apply it. I also have a hard time getting it right even though I am up to 20 times already putting it on and off.
The medium bell was too small for me, yet the medium condom too big. So that means small condom fits me, problem is, I have to use the medium bell for that, which is a bit too small.
I don't have the right to complain much, because I got mine for free, but I really just wish it could stick on for at least 3-4 hours without losing it suction every 10-20th minute.
I have tried the different techniques on rolling the condom over the penis, but almost every time I do it, the condom gets inverted somehow, and doesn't stick perfectly.
How do make sure there is no air between the bell and the sleeve? I find it quite challenging to control that as when you insert you gland in the bell it would pribably drag some air withit. After that you roll down the condom sleeve and then you pump the air out and thats greates suction. That is air is driven out as you pump. Is that right?
guys who are losing suction, did you try without protector cup?
Wo cup, a better seal I achieved.
Wo cup, a better seal I achieved.
Yes, didn't do anything different other than cause irritation after a few minutes. Too early.
Edit: Annnd now the medium one ripped.
Gonna have to wait for a new order... Too bad
Last edited:
imac
Retired Moderator, Member of the Month Nov 12, PE
After you enter the bell and roll the sleeve down, pump the air out and then look around the entrance of the bell to see if the sleeve has been sucked into the bell a bit to create a seal between the bell and your skin. Strap on the tension belt and look to see that seal is still air tight. If you notice that part of the seal is being pulled out and there's air trapped, release the tension and pump it up some more. I also found that I got a better seal when I didn't fully unroll the sleeve.
I'm still experimenting to see that works best.
- Joined
- Aug 7, 2013
- Messages
- 14,099
- Reaction score
- 325
- Points
- 0
There seems to be a lot of people ripping the condoms quite easily. Sort of glad I am not the only one that had this problem.
