REP Support for Phallosan Forte - Q & A

[Spoonman84]

I'm actually wanting the skin to peel off my glans to dekerantize them.

Jock I would just pump 3 times. I know you said before you have s big head and shaft to start with. Julian says it is not needed to fill the bell just get enough suction to hold.

 

[jockinthebox]

Thanks, Spoonman! Will DO!

 

[Tamora]

@ Spoonman & Tamora: Think I'll be OK as long as I wear a protective cap over my glans in starting back with my PF today? I never felt any pain or stinging when I got the blister, so I guess I'll just have to check him every few hours to keep tabs on it. Any other suggestions? Or should I give it another week or more?

Hey Jock...I really wouldn't want to advise you whether or not to start again now, just in case...all I will say is that some guys have started again after a couple of weeks rest and had no problem. You're obviously not over pumping, so if you're happy to give it another go now then that has to be your prerogative. If you do, I would check every half hour or so especially as you are not getting the "red flag" pinching sensation. For me, that sensation was pleasant and I remember sitting with it on one evening and thinking, "Mmmm...that feels nice! Feel like I'm getting a good pull!" When I took it off I had a blister right over my pee hole and that sucker stung like crazy for days every time I took a leak. Lesson learned!

I've dug out a couple of posts you might want to have a look at concerning blistering...might be worth a read:

https://www.pegym.com/forums/penis-devices-forum/63419-phallosan-forte-review-14.html#post937999

https://www.pegym.com/forums/penis-devices-forum/63419-phallosan-forte-review-14.html#post938101

https://www.pegym.com/forums/penis-devices-forum/63419-phallosan-forte-review-21.html#post1005563

ShaneC had recurring blisters...might be worth reading his thread too:

https://www.pegym.com/forums/progress-forum/68360-shanec-phallosan-progress-log.html#post789885


@JonPop...thanks for the recommendation.

I know Julian has recommended Bepanthen (nappy rash cream) in the past...never tried it, but if it works Jock not only will you heal quicker but your glans will be as smooth as a baby's bottom! :becky:

 

[jockinthebox]

Thanks, Tamora for some great history from guys in those threads! Some really good advice in there! I appreciate any advice on avoiding another blister, for sure! I've ordered the bruise cream JohPop recommended as well. I was an active Boy scout as a boy, so I learned early in life to "BE PREPARED"! THANKS, AGAIN!

 

[Maghed32]

Hi,

Anyone noticed any itchy skin from using the pf? My skin at the base of the shaft is really itchy in between using the device.

 

[Tamora]

Hi,

Anyone noticed any itchy skin from using the pf? My skin at the base of the shaft is really itchy in between using the device.

Sounds like you've got a bit of friction burn...try placing a soft cloth or handkerchief between you and the ring or wrapping the ring with something soft. Also, shave your shaft if you haven't already...pubic hairs used to make the irritation worse for me.

Hope this helps.

 

[jockinthebox]

Sounds like you've got a bit of friction burn...try placing a soft cloth or handkerchief between you and the ring or wrapping the ring with something soft. Also, shave your shaft if you haven't already...pubic hairs used to make the irritation worse for me.

Hope this helps.

Yeah, Tamora's right, definitely shave, including your perineum, and get some all-natural cocoa butter cream and apply that all the way around your package. I wear the ring around my entire package to reduce the friction burn issue. Cocoa butter is non-greasy and moisturizes the skin well to reduce irritation. I've found wearing the ring around my entire package also guards against slippage and keeps the tension better, too. You're not having to check the adjustment on the tension so much during the day.

 

[dared24]

Hi Julian, does the tension clip provide less tension over time. In other words, does the tension become less because of wear and tear over many months of use?

 

[johnhint]

Yea, my belt is losing some tension.
I've seen Julian accept request for belt replacements though. Whenever he does show up on this forum. Waiting on one currently.

 

[Tamora]

Hi Julian, does the tension clip provide less tension over time. In other words, does the tension become less because of wear and tear over many months of use?

Yea, my belt is losing some tension.
I've seen Julian accept request for belt replacements though. Whenever he does show up on this forum. Waiting on one currently.

Whilst you fellas are waiting on a reply from Julian, it's worth checking the height of the tension screws inside the clip. They will loosen over time, lessen the tension and need to be checked regularly...there should be approximately 27mm length of both screws protruding equally to the very top of the cheesehead screw.

This should give you a correct reading on the "traffic lights" and minimize squeaking.

Hope this helps.

EDIT: It is possible that the tension screws can be uneven from receipt of the goods due to shipment and whatnot. Mine were uneven from receipt and I sounded like I had a mouse in my pocket when I walked, so it is well worth checking their height when you receive the Phallosan. This could be eliminated by some Loctite threadlock (or similar) on the threads of the tension screws to prevent them coming loose.

 

[master bates]

Well.I hate to report this but during my phallosan usage the tension clip had broken wear the traffic light rods are. The one rod just snapped in half and Now I don't even see where I could purchase a replacement this puts my phallosan journey to a complete stop very depressing!!

 

[PDF]

If you send Julian an e-mail to [email protected], he should send you a replacement.

Well.I hate to report this but during my phallosan usage the tension clip had broken wear the traffic light rods are. The one rod just snapped in half and Now I don't even see where I could purchase a replacement this puts my phallosan journey to a complete stop very depressing!!

 

[Razor606]

I was wondering too if it would be possible to request a replacement for the foam ring, it has been torn off. It seems it is not able to order it online thru their website.

 

[Frankrizzo0420]

I tried putting the belt high up my back, and assisting the tension, but it still squeaks when I walk. ..

 

[Hah11]

Hi

I hope your well

I REQUIRE A REPLACEMENT CLIP

Again I am your number one fan

The item was purchased a long time ago. My best friend has a website where we review penis enlargement methods and devices. He reviewed the PHALLOSAN as amazing and light weight one of a kind traction technology

I do not have an information regarding order number, but I know it was purchased from phallosan ⬇⬇⬇

traction used 600g.
Scenario whilst damage: Item just snaped whilst on. Which is the most normal use.
1000hours usage

I also study journalism at university, I love the device as it's given me an inch gain.

I will put an article regarding the amazing gains it brings easily.

FAIR SOLUTION. Simply I request a replacement CLIP

This is my favourite device

I am your number one fan

 

[Tamora]

:mosking: :thumb:

 

[dared24]

Do you know how many months/hours the the tension clip should last before losing tension?

 

[Andyr]

Hi Julian,

Forgive me to ask, as this has maybe already been answered. I ordered the Phallosan primarily to straigthen a 30 degrees curvature to the left in my penis and secondly off course to gain lenght.
Should I keep the normal schedule of wearing it two days left and two days to the right or do you advise another schedule. Thanks.

 

[Tamora]

Do you know how many months/hours the the tension clip should last before losing tension?

Make sure the tension screws are set at the correct length to maintain tension...see previous post:

https://www.pegym.com/forums/penis-...upport-phallosan-forte-q-486.html#post1128415

The springs should (theoretically) last the lifetime of the device.

 

[Kratos1]

.......