I posted this 9 hours ago in the LG Hanger group, but no-one has responded. The instructions aren't clear about when the vacuum is applied, before the weight is attached or after? I noticed that my penis covers the air hole when placing my penis "down to the bottom" of the chamber as instructed, and causes a problem with getting even vacuum pressure around the glans. Any ideas of how to solve this? Although I wrapped as instructed, my glans got pinched/sucked into the air hole and it was going to give me a blister so I quit. Please advise.
LG Hanger questions
- Thread starter Tim the toolman
- Start date
donjelqer76
Retired Moderator, PEGym Hero
The pain-free tape has a pretty deep weave that will let air from around the entire glans exit to the vacuum port (the same principle is used in vacuum bagging composites). Even though they say you don't need to tape in the beginning, I would recommend it for this very reason.
Can you describe your taping method?
Also, the weight should be applied after the dome is secured and vacuum applied
Can you describe your taping method?
Also, the weight should be applied after the dome is secured and vacuum applied
Well a blister developed the next day, even though I had the LG Hanger on only a few minutes. I mistakenly applied vacuum up to 10, so that may have caused it. I placed my wrap around the glans and fold in the ends over each other to cover the urethra, as instructed (or at least how I interpreted the instructions).
So I'm thinking that "a 7-8" strip" isn't enough coverage, so after I heal from the small blister, I'll try covering the glans top to under side (about a 5" strip), then wrap the 7" strip around the glans covering and mold together to see how that works. I also thought about placing a short rubber balloon over the wrap to contain the wrap further and provide additional protection.
So I'm thinking that "a 7-8" strip" isn't enough coverage, so after I heal from the small blister, I'll try covering the glans top to under side (about a 5" strip), then wrap the 7" strip around the glans covering and mold together to see how that works. I also thought about placing a short rubber balloon over the wrap to contain the wrap further and provide additional protection.
