REP Support for LG Hanger - Q & A

[Dr Ric]

I will be glad to explain it. When one attaches the LG hanger you have forces that pull in two basic directions. One is down, the other is to the side. The down vector force, increases the length, whereas to the side initiated by the vacuum force and the weights working in conjunction causes the collagen to be remodeled for greater girth. I've had a number of students comment on this observation, this is why the hanger was initially called LG hanger, for length and girth. In other words the students observed their glands and areas of the shaft to develop greater girth.

In summary, then you have two significant vector forces one pulling down causing collagen remodeling in length direction, and one pulling to the side under vacuum, causing girth increase collagen remodeling. The bottom line is for permanent gains, the collagen must be remodeled. I trust this sheds some light on the question.
If you have not done so please read my article on The Exact Mechanism Of Penis Enlargement.

 

[Dr Ric]

Hello,

Here's a comment by a user of the LG hanger. He uses the LG hanger as a primary traction device that causes the collagen remodeling and thus the enlargement process, and the phallosan belt to maintain the hanger under an all-day traction scenario. This makes intuitive sense, first you use the primary device that allows you to exceed 10 pounds after you have safely worked up to that level, to initiate collagen remodeling and penis growth, secondarily if you are motivated, you can hold the penis in an extended state, which will make for greater efficiency in terms of growth. Below is what was just said by this gentleman:

"FIRST.....my hanger is unreal!!! Best results so far. I started slow but I am up between a 1/2 to 3/4 of an inch. I use it in conjunction with my belt I got from Phallosan. It is what helps me keep my gains. "

In addition, I have had a similar response from a student that the combination is very effective. There is a motivational factor here that each individual must decide on, but the concept of such a scenario is compelling, and probably will work quite well. LG Hanger does offer an all-day stretching device, that is far less expensive than the Phallosan: lghangerllc.com .

 

[Dr Ric]

Struggling with consistency....I had a good solid 8 weeks of hanging but the last 2 have been pants...work and private life taking over. The next two weeks though I can get back some kind of consistency due to shifts...question is, will this broken approach stop me gaining anything. Prior to the last 2 weeks my flaccid hang was heavier, erections were on point too. Is there anything I can do that can help when having these weeks of rubbish shifts...


Any advice is appreciated

Hello,


These would be the exercises. I would recommend when there are times that you cannot use equipment:


1. A combination grouping of Cagle's, edging, and base squeezes. The amount that you do it is up to you, as I do not know you or know your level of advancement, except in the most general way. I've found this to be very useful in terms of maintaining size and function.


2. The stretch category in the angles that you find to be most helpful, it is generally accepted that BTC is one of the better categories, but experiment with this. You can also do a variety called the bundled stretch in the angles that you find to be agreeable. I would not recommend turning your penis clockwise or counterclockwise ,at first, more than one half turn . Always start out conservatively in a new exercise, which may or may not be true in your case.


3. It's a category that I encountered by experimentation, I call it the bundled dry jelq. In other words, you do a bundled stretch, and dry jelqing. I have found this to be particularly helpful, and is one of my primary exercises.


I trust this sheds light on your questions.

 

[jackjohnson]

I'm actually in week 9...currently 7lb. I do for weeks at at weight then increase by 1lb. Doing 3x20 mins per day. I think in week 13 I will increase the sets to 4 but remain at 7. If this feels too comfortable then I will increaee to 8...listening to my dick of course though. So a month at a weight....my fflaccid certainly better, cantvsay erections are though....

why only 20 minutes? I believe you can go up to 1 hour with the LG ?

Also, have you made any gains so far with LG?

 

[jackjohnson]

People that use the LG, do you use -7 HG? Or are you going higher or lower?

 

[Cool-Since-92]

People that use the LG, do you use -7 HG? Or are you going higher or lower?

Lower but it depends on how much weight your hanging.

 

[jackjohnson]

I am circumcised. I am using the blue tender tape. When I pump, my glands is getting sucked into the top hole in the glass dome chamber. I can visibly see the blue tender tape along with my glans getting sucked into the top hole.

How do you guys avoid this from happening?

 

[jackjohnson]

I attach the pump for 5 minutes at -5Hg before adding the weight.

Before I add the weight I reconnect the pump to check the Hg.

When I reconnect the pump, the Hg is at -1 . Is this normal?

I then repump back up to -5Hg and then add the weight, but I don't know if I am keeping constant Hg throughout.

 

[Marlon LGHanger]

I am circumcised. I am using the blue tender tape. When I pump, my glands is getting sucked into the top hole in the glass dome chamber. I can visibly see the blue tender tape along with my glans getting sucked into the top hole.

How do you guys avoid this from happening?

How much Hg are you using? Try using a little more wrap on the end of your penis. The end of your penis should bottom in the chamber, but if you sucking up into the vacuum port hole that sounds like too much vacuum pressure being used.

 

[Marlon LGHanger]

I attach the pump for 5 minutes at -5Hg before adding the weight.

Before I add the weight I reconnect the pump to check the Hg.

When I reconnect the pump, the Hg is at -1 . Is this normal?

I then repump back up to -5Hg and then add the weight, but I don't know if I am keeping constant Hg throughout.

What you describe is normal. Keep in mind that 5 hg of vac pressure is extremely small. If you had a thick milkshake that you were trying to drink with a straw, the amount of suction you would exert while trying to draw the milkshake through the straw would exceed 5 hg.

That however doesn't mean you have an unsecure chamber. It's good that you prime the chamber first, just reattaching the hose into the chamber can allow the 5 hg to escape. So re-priming while you attach weight is fine.

 

[Marlon LGHanger]

People that use the LG, do you use -7 HG? Or are you going higher or lower?

Use only what you need to secure the chamber and keep the weight from slipping. I seldom ever go over 10 Hg even when using as much as 18 lbs.

 

[jackjohnson]

I am currently using -5Hg with the 3lb weight.

I will try to use 10-12 inches of wrap instead of the 8 inches. When I fold it over this may help with getting my dick sucked in.

 

[jackjohnson]

Use only what you need to secure the chamber and keep the weight from slipping. I seldom ever go over 10 Hg even when using as much as 18 lbs.

Do you perform 1 hour sets with 18 lbs? And how many sets per day are you doing ?

 

[jackjohnson]

Thought this was relevant.

You should pump to required pressure before you drop the weight, correct?
This is somewhat subjective. There are a couple different ways to achieve the same result. It's really a matter or preference. It also depends on how much weight you are attempting to hang. For example when I am hanging 8 lbs., I draw out about 3 hg of vacuum pressure and hook the weight up to the chamber, lower it until it is hanging onto my penis all by itself. I take a look at the gauge and it will read about 5 hg, The weight alone primed the pressure up another 2 hg. That is sufficient for me to hang 8 lbs. When I go up to 10 lbs and above, I do the same, except as I allow the weight to hang I draw the desired pressure I need to allow the weight to hang without slipping off ..... which is about 10 hg. So draw up to 5 hg, allow the weight to hang, it will spike up a couple more hg, and then draw out the remainder up to 10 hg and disconnect hose. Even when I hang up to 17 lbs. I never need more than about 15 hg. of pressure.

 

[Marlon LGHanger]

Thought this was relevant.

You should pump to required pressure before you drop the weight, correct?
This is somewhat subjective. There are a couple different ways to achieve the same result. It's really a matter or preference. It also depends on how much weight you are attempting to hang. For example when I am hanging 8 lbs., I draw out about 3 hg of vacuum pressure and hook the weight up to the chamber, lower it until it is hanging onto my penis all by itself. I take a look at the gauge and it will read about 5 hg, The weight alone primed the pressure up another 2 hg. That is sufficient for me to hang 8 lbs. When I go up to 10 lbs and above, I do the same, except as I allow the weight to hang I draw the desired pressure I need to allow the weight to hang without slipping off ..... which is about 10 hg. So draw up to 5 hg, allow the weight to hang, it will spike up a couple more hg, and then draw out the remainder up to 10 hg and disconnect hose. Even when I hang up to 17 lbs. I never need more than about 15 hg. of pressure.

With our new rubber being so much better to handle heavier weight, I have been able to use less vacuum Hg pressure.

 

[Marlon LGHanger]

Do you perform 1 hour sets with 18 lbs? And how many sets per day are you doing ?

No - I do not do full one hour sets with 18 lbs. I graduate up to that amount throughout the hour. Lately I haven't been exceeding 15 lbs, and usually that is for only 10-15 minutes at the end of the session, in which I started out with lighter weight increments. My time has been limited by my work schedule and the relocation of our equipment to new commercial floor space, along with a residence relocation too. I have been lucky to get in 5 hours of hang time per week @ one session in the morning. As time permits I will get back to two sessions per day. I am thinking of trying a longer session of 2 - 3 hours with a lighter weight of 5 - 6 lbs and seeing how I respond. The morning session will be heavier.

 

[wroey]

why only 20 minutes? I believe you can go up to 1 hour with the LG ?

Also, have you made any gains so far with LG?

I do suffer with edema so just been breaking myself in very gradually. From monday i will be doing 30 mins sets staying at 7lb. My penis seems to be more conditioned now and i feel it is ready...guess its all about knowing your body.

As far as gains...well one of my recent posts i talked about struggling with consistency...this was due to work and relationship .i have previously had all the positive indicators but again life got in the way. Ive bern single last 3 weeks so have foundvthe consistency agsin and i have again got all the positive signals...bigger flaccid, better erections and so on. In all my timebi have never hung above 7lb...however, from monday i will up the time and stay at 7lb for two weeks then stay at 30 mins but look to increase weight to 8lb..if ready, if not ill wait another 2 weeks then up the weight....

 

[lilthing]

Is the website down? Keeps saying "file not found"

 

[lilthing]

I got the website working now. Although I am attempting to order and at no point am I being asked for my measurements. Also is seems as though paypal is the only method allowed for payment. I don't have a paypal account.

Please advise

 

[Marlon LGHanger]

I got the website working now. Although I am attempting to order and at no point am I being asked for my measurements. Also is seems as though paypal is the only method allowed for payment. I don't have a paypal account.

Please advise

Once you place an order, we send you a link to watch our measurement video. You can Google the You Tube video by entering "LG Hanger measuring video" - We need your erect circumference around the shaft diameter of your penis.

You don't need a PayPal account to order. PayPal will let you use your credit card. It's completely secure, and that is why we use that method for payments.